White LED welding technology requirements

The requirements for blue and green LED soldering are the same as those for white LEDs. In terms of the level of general white LED soldering, there are such basic requirements. The operation needs to be noted as follows:

1. Always wear anti-static gloves, anti-static wrists, and electric irons must be grounded during production. It is strictly forbidden to touch the two lead pins of white LEDs with bare hands. Because the anti-static of white LED is 100V, and the working humidity on the workbench is 60%-90%, the static electricity of the human body will damage the crystal layer of the LED. After working for a period of time (such as 10 hours), the diode will be ineffective (not lit). ), will be invalid immediately if it is serious.

2. The soldering temperature is 260 ° C for 3 seconds. If the temperature is too high, it will burn out the chip if it takes too long. In order to better protect the LED, the LED colloid and the PC board should be kept at a distance of 2mm or more, so that the solder heat is dissipated in the pin.

3. The normal working current of the LED is 20mA, and the small fluctuation of the voltage (such as 0.1V) will cause large fluctuations in current (10%-15%). Therefore, in the circuit design, different current limiting resistors should be paired according to the voltage drop of the LED to ensure that the LED is in the best working condition. If the current is too large, the LED will shorten the life and the current will be too small to reach the required light intensity.

Generally, the LEDs are separated by color separation, that is, the LED light intensity, voltage, and light color in the same package are consistent, and are indicated on the spectrometer.

Brushless Motor

DC Motor,Rc Brushless Water Pump Motor,48V Brushless Dc Motor,High Speed 12V Brushless Dc Motor

DC Motor ,Gear Motor,Co., Ltd. , http://www.bosacmotors.com

This entry was posted in on